What does gradient mean for wastewater pipes?
Most wastewater pipes in buildings and on plots work as gravity pipes: the water flows without a pump, by gravity alone, from the highest to the lowest point. For this to work, every horizontal pipe must be slightly inclined along its entire length. This inclination is called the gradient or fall and is stated as a difference in height per length, for example in per cent or per mille.
A gradient of one per cent means, for example, that the pipe invert drops by one metre over a hundred metres. Which values apply to a particular pipe depends on its function, the diameter and the type of wastewater. In Switzerland, the standard SN 592 000 sets out the requirements for property drainage; planners and installers follow it.
Why the right gradient is so important
Wastewater carries not only water but also solids: faeces, paper, food scraps, fat and sand. For these to be carried along, a sufficient flow velocity is needed. If the gradient is too shallow, the water flows too slowly, solids settle and over time form a solid layer that narrows the cross-section.
An excessively steep gradient is not ideal either, because the water can then run ahead and leave solids behind; it also causes noise and greater wear. Vertical pipes are a special case: they run vertically, and the transition to the horizontal pipe is designed with bends and a suitable calming section so that the water flows on smoothly.
Sags, reverse falls and deflections
Deviations that arise after installation are particularly problematic. If the ground beneath an underground drain settles, the pipe sinks in places and forms a sag in which water stands permanently. Solids are deposited there, and in winter the standing water can cause additional damage in pipes at risk of frost.
A reverse fall is when a section actually runs uphill – usually the result of installation errors or settlement. Plastic pipes laid without adequate bedding can also deflect. All these faults typically show up as blockages that return at the same spot some time after each cleaning.
Measuring the gradient and detecting sags
You cannot tell from the outside whether a pipe's gradient is correct. The most reliable finding comes from a CCTV drain survey. Modern inspection systems measure the inclination of the camera crawler and create a gradient profile of the pipe. In addition, the image shows standing water collecting in sags – a clear sign of an irregularity.
With new pipes, the gradient is already checked during laying with a levelling instrument or laser and approved before backfilling. With existing installations, property drainage drawings and level readings in the manholes help to interpret the camera's measurements and to pinpoint the affected sections precisely.
What to do if there is no gradient?
Trenchless methods such as CIPP liners follow the existing pipe. They seal cracks and joints, but do not correct a gradient or lift a sag. If the gradient is the real problem, the affected section usually has to be relaid using open-cut construction – with proper bedding and a controlled gradient.
If relaying is not possible for the time being or would be disproportionate, adapted maintenance helps: regular high-pressure water jetting at fixed intervals keeps the sag clear before deposits harden. On the basis of the CCTV drain survey, a specialist company can assess which solution makes economic and technical sense.
In a terraced house in Uster, the underground drain to the inspection chamber became blocked about twice a year. Each cleaning only helped for a few months. The CCTV drain survey with inclination measurement showed a sag around three metres before the manhole, in which water stood permanently and deposits collected – the result of settlement after garden work. The section was exposed using open-cut construction, placed on new bedding and reconnected with the correct gradient. Since then the pipe has been running without any problems.
