What is a soil stack?
The soil stack is the vertical main pipe of a building’s drainage. On every floor, the short branch pipes from the washbasin, shower, bath, WC, kitchen sink and washing machine discharge into it. The wastewater falls down the stack by gravity and, in the basement or below the floor slab, is diverted via a bend into the horizontal underground drain, which carries it on to the public sewer system.
An apartment building usually has several soil stacks, for example one for the kitchens stacked above each other and one for the bathrooms. In modern buildings, the downpipes for roof water run separately. Soil stacks are planned and sized according to SN EN 12056 for gravity drainage systems inside buildings and SN 592 000, the Swiss standard for property drainage.
Design and venting of the soil stack
A soil stack consists of straight pipe lengths, branches for the floor connections, rodding eyes and, at the lower end, a bend into the underground drain. Depending on the year of construction, the pipes are made of cast iron, fibre cement, plastics such as PE or PP, or sound-insulated plastic systems. Older properties often still have cast-iron pipes, which corrode on the inside and become rough.
To prevent the falling water from creating negative pressure, the stack continues above the roof as a vent pipe. If this vent is missing or blocked, the draining water sucks the traps in the flats dry. The result is gurgling drains and a drain smell in the bathroom – a common sign of a problem in the soil stack rather than in an individual washbasin.
Typical problems in the soil stack
The most common fault is a blockage in the lower section, where the stack joins the underground drain. This is where grease from the kitchen, soap residue, hair and wet wipes collect. Because the wastewater slows down in the bend, deposits settle there particularly easily. If water backs up on the ground floor or in the basement while it still drains upstairs, the plug is usually right there.
Over the years, encrustation of limescale and urine scale also builds up and narrows the cross-section. Cast-iron pipes also suffer from corrosion and rust nodules. Leaking joints show up as damp patches in ducts or walls. If such damage is not repaired, water damage in several flats and expensive follow-on costs are likely.
Cleaning the soil stack
Depending on the cause, a soil stack is cleaned mechanically or with high-pressure jetting. For an acute blockage, specialists use a drain snake via a rodding eye or from the roof. For grease and stubborn coatings, high-pressure water jetting with a suitable nozzle that flushes the pipe wall clean all round is the right choice. Limescale and urine scale are removed with milling or chain flail tools.
After cleaning, a camera survey is worthwhile in many cases. It shows whether the stack is really clear, whether there are cracks or leaking connections and whether rehabilitation is due. For properties with recurring blockages, regular preventive jetting has proven effective.
Rehabilitating an old soil stack
If a soil stack is leaking or badly corroded, it does not necessarily have to be broken out of the walls. Trenchless methods such as a CIPP liner or an internal coating renew the pipe from the inside, while the flats largely remain habitable. Branches to the floors are reopened and sealed with a robotic cutter after installation.
Which method is suitable depends on the material, diameter, bends and condition. The basis is always a careful inspection. For stack rehabilitation as part of a complete renovation, conventional replacement can also make sense, for example if bathrooms and kitchens are being refitted anyway.
What owners and property managers should bear in mind
In rented properties the owner is responsible for the soil stack; in condominium ownership it is usually the owners’ association, because the stack is a common part. It is worth recording the location, material and rodding eyes of the stacks in the documentation. This allows specialists to act quickly in the event of a fault.
It also helps to inform residents: grease, food scraps and wet wipes do not belong in the drain. This simple rule prevents a large share of soil stack blockages.
In an apartment building from the 1970s in Winterthur, wastewater on the ground floor kept draining slowly, while the flats upstairs had no problems. The camera survey revealed a thick coating of grease and limescale in the lower bend of the kitchen soil stack. The team jetted the stack clear with high pressure and a rotating nozzle and removed the encrustation mechanically. Because the cast-iron stack was also badly corroded, the report recommended rehabilitation with a liner at the next renovation.
