What is an oil separator?
An oil separator is a tank or chamber that is built into the drainage system and separates light liquids from water. It uses the physical principle that mineral oils have a lower density than water: in a calmed flow, they rise to the surface, while the cleaned water flows on below.
The technical term is light liquid separator; sizing, design and testing are governed by the European standard SN EN 858. In everyday use, the terms oil separator, mineral oil separator and petrol interceptor are common – in each case, the same type of installation is meant.
How a mineral oil separator works
The installation usually has two stages. First, the wastewater flows into a sludge trap, where sand, sludge and other heavy substances settle. It then passes into the separator itself, where the oil collects at the surface. In class I installations, a coalescence insert ensures that even the finest oil droplets combine into larger drops and rise.
An automatic closure device with a float closes the outlet when the oil layer reaches the maximum storage volume. This means that no collected oil can get into the sewer system. Many installations also have an alarm system that signals a high oil level or backflow.
Where is an oil separator required?
An oil separator is required wherever wastewater containing mineral oil can arise. Typical examples are car garages and workshops, petrol stations, vehicle wash bays, businesses with machinery fleets, municipal depots, and parking and transfer areas for vehicles and construction machinery.
Whether an installation is needed in an individual case, and which one, is governed by water protection law and the requirements of the canton and municipality. For underground garages and car parks, cantonal practice and the type of drainage sometimes differ considerably. What counts is therefore always the property’s drainage permit and the information from the competent cantonal office.
Emptying, servicing and disposal
An oil separator only works reliably if the sludge trap and the oil layer are removed regularly. If the installation is emptied too rarely, the separation performance drops, the coalescence insert becomes blocked and the automatic closure device can be triggered – the wastewater then backs up. Many businesses therefore have their installation checked by a specialist company at fixed intervals.
During emptying, the contents are sucked out with the vacuum tanker, the installation is jetted and the coalescence insert is cleaned. The extracted oil-water mixture is classed as special waste and must be disposed of and documented in accordance with waste legislation. The operator should keep the servicing records, as the authorities can ask for them during inspections.
General inspection and watertightness
In addition to routine servicing, SN EN 858 recommends a comprehensive inspection of the installation in its emptied state at longer intervals. This checks the structural condition of the tank, the internal fittings, the float closure and watertightness. Cracks or leaking connections can allow oil to get into the subsoil unnoticed.
Older concrete installations often show corrosion damage to the walls and covers. This can often be repaired with manhole rehabilitation, without replacing the whole installation. The inlet and outlet pipes should also be inspected by camera on this occasion.
A garage business in Wil SG reported that the water at the wash bay was draining away more and more slowly. The inspection showed an almost full sludge trap and a closed float in the mineral oil separator. Karo sucked out the sludge and oil with the vacuum tanker, cleaned the coalescence insert, jetted the inlet pipe and checked the outflow with the camera. The business received a report for its records and a fixed servicing interval, so that the separator no longer fills up unnoticed in future.
