GlossaryDrainage technical term

Stormwater retention

Also: Rainwater retention, Retention basin

Retention means temporarily holding back rainwater during heavy rainfall and releasing it again in measured amounts. Retention systems on properties ensure that sealed surfaces do not suddenly overload the sewer system. In many Swiss municipalities they are mandatory for new builds with large roof and yard areas.

Drain works at a scaffolded new build, service vehicle with open tailgate

In brief

Retention means holding back rainwater and releasing it with a delay. A retention system – a tank, storage chamber, storage pipe or green retention roof – fills up in heavy rain and slowly releases the water through a flow restrictor to the sewer system, a stream or an infiltration system. Municipalities often require one when a property has a lot of sealed surface and the network needs relief.

What does retention mean in drainage?

When rain falls on roofs, roads and car parks, it runs off much faster than on meadows or woodland. Without countermeasures, large volumes of water reach the sewer system in a short time, and it is not designed for this everywhere. The consequences are backflow, flooded basements and, in combined systems, discharges of untreated wastewater into watercourses.

Retention breaks this peak flow. The water is collected in a storage unit and passed on through a flow restrictor only in the quantity that the downstream network can cope with. After the rain, the storage gradually empties until it is ready again for the next event.

Types of retention system

Common on properties are underground retention tanks made of concrete or plastic, enlarged chambers with a flow control device, and large-diameter storage pipes that also serve as storage. Above ground, swales, shallow depressions on green spaces or car parks and green retention roofs are used.

Retention is often combined with infiltration: part of the water infiltrates and the rest drains away at a restricted rate. On a larger scale, municipalities operate stormwater tanks and storage sewers in the public network. What matters for the property, however, is its own system, which the owner must maintain.

When does the municipality require retention?

Whether retention is needed, and to what extent, is set out in the general drainage plan (GEP) and the wastewater regulations. The municipality often sets a maximum permissible discharge that a plot may release into the sewer system or a watercourse during rain. Anything above that has to be held back on the plot.

Sizing and construction follow the VSA guideline ‘Wastewater management in wet weather’ and SN 592 000. The specific values vary locally; the designer obtains them from the building department. With climate change and more frequent heavy rain, many municipalities are placing more emphasis on retention and sponge city measures.

The flow restrictor: a small component with a big effect

The heart of every retention system is the flow control device – an orifice plate, a vortex flow control or a gate valve that limits the outflow. If the restrictor is blocked, the storage fills up and eventually overflows, even though the system would be large enough. If it has been removed or tampered with, the system loses its effect and the network once again receives the full peak.

Because flow restrictors have small openings, leaves, sand and litter readily collect in front of them. An upstream silt trap and regular checks are therefore crucial. After every major storm, it is worth taking a look into the restrictor chamber.

Cleaning and maintenance

Retention tanks and storage chambers collect sediment with every rainfall. Over time this reduces the usable volume and causes odours. A combined jetting and vacuum vehicle removes the sludge, and the inlet and outlet pipes are jetted at high pressure and checked by camera if necessary.

A fixed maintenance schedule with checks of the flow restrictor, emergency overflow, inlet and silt trap makes sense. In condominium ownership or commercial properties in particular, the system is otherwise quickly forgotten until the first heavy rain floods the underground car park.

Practical example

A housing development in Dübendorf had an underground retention tank beneath the playground. During a summer thunderstorm, water suddenly appeared in the underground car park entrance. The inspection revealed that a plug of leaves and gravel had formed in front of the orifice plate; the tank was full and the emergency overflow was backing up. The team vacuumed out the tank and silt trap, jetted the flow restrictor clear and checked the outlet pipe by camera. The property management company has since included the inspection in the annual maintenance schedule.

Stormwater retention: frequently asked questions

What is the difference between retention and infiltration?+

Retention holds back rainwater and passes it on at a restricted rate to the sewer system or a watercourse. Infiltration channels the water into the ground. The two are often combined: what can infiltrate does so, and the rest is held back and drained with a delay.

Do I have to build a retention system?+

That depends on the municipality. Many set a maximum discharge via the general drainage plan and the wastewater regulations. If the property’s runoff exceeds this, the building permit requires retention. The building department will give you the values for your plot.

How is a retention system cleaned?+

With a combined jetting and vacuum vehicle: sludge and sediment are vacuumed out, inlet and outlet pipes are jetted at high pressure and the flow restrictor is cleared. If necessary, a camera survey checks the pipes. Checking the silt trap and emergency overflow is also important.

How can I tell that the retention is not working?+

Warning signs are water standing in the chamber for a long time after rain, overflowing at inlets or in the underground car park, odours from the storage and a visibly blocked flow restrictor. The system should then be inspected and cleaned promptly.

Stormwater retention in your region?

We are there for you across German-speaking Switzerland – fast, clean, with a 24/7 emergency service.