What is a general drainage plan?
The GEP is a comprehensive municipal planning document for urban drainage. It covers the entire municipal area: sewers, special structures such as stormwater tanks and pumping stations, watercourses, infiltration options and the link to the wastewater treatment plant. The aim is drainage that protects watercourses, prevents flooding and remains affordable in the long term.
The obligation to carry out municipal drainage planning arises from the federal Water Protection Act and Water Protection Ordinance. The cantons review and approve the GEP. On the technical side, municipalities follow the model approach and guidelines of the VSA, the Swiss association of wastewater and water protection professionals.
What does a GEP contain?
A GEP consists of several sub-projects. These include the condition report on the sewer network, usually based on CCTV drain surveys, reports on infiltration water, watercourses and infiltration, and hydraulic calculations showing whether the pipes can cope with heavy rain. From these, a drainage concept with measures and priorities is derived.
The infiltration map is particularly important for owners. It shows where rainwater can or must be infiltrated, where retention is required and where rainwater may be discharged into a stream or the sewer system. The GEP also specifies the areas in which the combined system is to be replaced by a separate system.
What does the GEP mean for properties?
Anyone building, converting or redesigning their outdoor areas will feel the GEP’s requirements through the building permit. The municipality can require roof water to be infiltrated or discharged with a delay, foul water and rainwater to be run separately up to the plot boundary, or an inspection chamber to be built.
Existing properties are also affected. If the municipality plans to switch a neighbourhood to the separate system or rehabilitates the street sewers, the private connections are often checked at the same time. Owners are then asked to have their pipes investigated and to have leaking or wrongly connected pipes rehabilitated.
The GEP and private pipes
The GEP deals primarily with the public network. Many municipalities, however, supplement it with a survey or inspection of private wastewater installations, because a large share of the pipe length and of the infiltration water lies on private plots. Leaking house connections and wrongly connected land drains load treatment plants with clean water.
It is therefore worth owners knowing the condition of their own pipes. A camera survey with a report according to SN EN 13508-2 and a condition rating provide clarity and make communication with the municipality easier if a request for rehabilitation arrives.
Where can I find my municipality’s GEP?
The GEP is held by the municipal administration, usually at the building department or civil engineering office. Many municipalities and cantons make parts of it, such as infiltration maps or the sewer cadastre, available online in a geoportal. For a specific construction project, the building department can tell you which requirements apply to the plot.
GEPs are revised periodically because settlements, the climate and requirements change. Many municipalities are now working on a second-generation GEP, which gives more weight to dealing with heavy rain and preserving the value of the network.
A family in Wetzikon was planning to add a conservatory. In the building permit, the municipality referred to the GEP: the neighbourhood lies in an area where rainwater is to be infiltrated, and the existing roof water pipe was still connected to the combined sewer. Before the conversion, the property drainage was surveyed by camera and located. Since then the roof water has been fed into an infiltration system in the garden and the foul water still goes into the sewer – just as the GEP provides.
