GlossaryDrainage technical term

Sewer pipe

Also: Wastewater pipe, Drain pipe, Sewerage pipe, Drainage pipe

Sewer pipes carry a property's wastewater from the building to the public sewer system. What material they are made of depends mainly on the year of construction – and the material helps determine what damage occurs and how a pipe can be cleaned and rehabilitated.

Sewer pipe and wastewater pipe: materials and trenchless rehabilitation with a CIPP liner

In brief

A sewer pipe is a pipe that carries foul water or rainwater by gravity to the sewer system. Depending on the year of construction, Swiss properties have pipes made of vitrified clay, concrete, asbestos cement, cast iron or plastic (PVC, PE, PP). Each material ages differently: for the right cleaning and rehabilitation, you first need to know what is in the ground.

What is a sewer pipe?

A sewer pipe is any pipe that carries wastewater away – from the drain in the kitchen through the soil stack to the underground drain beneath the floor slab and the house connection to the public sewer system. In everyday language, the terms sewer pipe, wastewater pipe and drain pipe are mostly used interchangeably. Specialists tend to speak of wastewater pipes inside the building and of sewer pipes as soon as the pipe is in the ground.

Unlike a drinking water pipe, a wastewater pipe is not under pressure. The water flows by gravity alone. That is why an even gradient, smooth inner walls and tight joints are so important: where the pipe sags, is displaced or has rough spots, solids are left behind, and deposits and blockages form.

This page is about the pipe itself – about materials, diameters, ageing and rehabilitation. The types of pipe in a house, from the connecting pipe to the soil stack, are explained under the glossary term wastewater pipe.

Which pipe materials are found in Swiss properties?

Vitrified clay is fired and glazed clay and one of the oldest materials for sewer pipes. It is highly resistant to acids and abrasion, but brittle. The weak point of older vitrified clay pipes is the joints: in the past, the sockets were sealed with mortar or tarred rope, which become leaky over the years.

Concrete pipes are found mainly in larger diameters, in collector pipes and manholes, but in older properties also as underground drains. Concrete is load-bearing and inexpensive, but is attacked by aggressive gases in the wastewater. Asbestos cement pipes – often called «Eternit pipes» after a brand name – were installed in Switzerland until the asbestos ban of 1990 (with transition periods for individual products). They are light and long-lasting, but must not be drilled, milled or broken without controls.

Cast-iron pipes are used mainly inside buildings, for example for soil stacks and collector pipes on the basement ceiling. They are heavy, quiet and non-combustible, but can corrode on the inside. Older cast-iron pipes have sockets with caulked seals; newer ones are socketless and connected with clamps.

Plastic pipes have largely replaced the older materials in recent decades. PVC pipes are rigid and light and are connected with push-fit sockets and sealing rings. PE pipes made of polyethylene are welded and are therefore particularly tight; they are widespread in Swiss building drainage. PP pipes made of polypropylene are push-fit and are often used as sound-insulated domestic waste pipes, but they are also available as buried sewer pipes.

Year of construction, material and typical age

The year a property was built is the best first clue to the pipe material. As a rough guide: in houses built before about 1970, vitrified clay, concrete or asbestos cement pipes are often found in the ground, and cast iron is often found inside the building. From the 1970s onwards, plastic pipes were increasingly added, but asbestos cement was still used until 1990. Since then, new wastewater pipes have almost always been made of plastic.

This classification is only a rule of thumb. Many properties have been converted, extended or partially rehabilitated, so that several materials lie one after another in a single pipe run – for example a new PE pipe in the basement that joins an old vitrified clay underground drain. It is precisely the transitions between two materials that are often leaky or displaced.

How long a sewer pipe lasts therefore cannot be expressed as a fixed number of years. What matters is the quality of the laying, the bedding in the ground, the load from above, trees nearby and the composition of the wastewater. A carefully laid vitrified clay pipe can last a very long time, while a poorly bedded plastic pipe can be deformed after a few years. Only a camera inspection answers the question reliably.

Typical damage patterns by material

With vitrified clay, leaking and displaced joints are the most common finding. Roots grow in through the open joints, and soil is washed in. Because the material is brittle, settlement or traffic loads cause longitudinal and circumferential cracks, up to fragmentation, where the pipe wall has broken into individual pieces.

Concrete is attacked from the inside: hydrogen sulphide in the wastewater produces sulphuric acid above the water line, which dissolves the cement. This is known as biogenic sulphuric acid corrosion. The surface becomes rough, aggregates are exposed and the wall becomes thinner. On top of that come cracks and leaking pipe joints. Asbestos cement shows similar washing out as well as cracks and breaks; any mechanical work is particularly delicate here, because fibres can be released.

Cast-iron pipes rust from the inside. Rust and deposits of limescale and grease narrow the cross-section, encrustation forms, and holes develop at thin spots. Plastic pipes do not corrode, but they can deform under load or sag if bedded incorrectly. With PVC and PP push-fit sockets, pipes slide apart or sealing rings shift; older PVC pipes can become brittle and crack.

Common to all materials are deviations in alignment, reverse gradients and intruding connections. This damage usually arises during construction or during later work near the pipe and means that deposits form again and again at the same point.

Nominal diameter: how big is a wastewater pipe?

The size of a wastewater pipe is given as the nominal diameter, abbreviated DN. It corresponds roughly to the internal diameter in millimetres. In the trade, plastic pipes are often designated by their external diameter; a PE pipe with an external diameter of 110 mm corresponds roughly to a nominal diameter of DN 100. Anyone who wants to replace or extend a pipe therefore needs to know which figure is meant.

Inside the building, connecting pipes from washbasins, showers or sinks have small diameters in the range of around 40 to 56 mm. WC connections and soil stacks are usually in the range of around 90 to 110 mm. Underground drains and house connections are larger; the minimum nominal diameter that applies results from the design according to the standard SN 592 000 and the municipality's drainage regulations.

The nominal diameter is also important for rehabilitation. A CIPP liner reduces the cross-section by a few millimetres, and not all methods are possible for small pipes in the house. Before any rehabilitation, the nominal diameter is therefore measured during the camera inspection and recorded in the survey report.

Which rehabilitation method suits which material?

The CIPP liner (cured-in-place pipe) is suitable for almost all materials – vitrified clay, concrete, asbestos cement, cast iron and plastic. A resin-impregnated liner is inserted into the cleaned pipe and cures there to form a new, tight pipe within the pipe. The old pipe stays in the ground as a casing. With asbestos cement in particular this is a great advantage, because the pipe does not have to be removed.

For individual defects such as a crack or a leaking joint, a patch liner (Pointliner) that seals only the damaged point is often enough. Pipes with many bends and branches, such as cast-iron pipes inside the building, can be rehabilitated with a coating such as spray lining. Beforehand, roots, encrustation and intruding connections are removed with the robotic cutter.

Trenchless methods reach their limits when a pipe has collapsed, has a severe reverse gradient or is fundamentally too small. Then the pipe is replaced by open-cut construction or renewed by pipe bursting: a bursting head breaks up the old pipe in the ground and pulls a new one in behind it in the same pass, which requires a launch pit and a reception pit. With asbestos cement, destroying the old pipe is generally ruled out because of the fibres; removal is then carried out only in accordance with Suva requirements.

Karo gives a warranty of up to 10 years on rehabilitation work, depending on the method and scope; the exact period is stated in the quote. Which method makes sense is decided after cleaning and the camera inspection, whose findings are coded in accordance with SN EN 13508-2.

Determining the material: camera inspection instead of guesswork

From the outside, you can rarely tell what a sewer pipe is made of. Building plans, the property's drainage plan and visible pipe sections in the basement or in the inspection chamber provide clues. Only the camera image gives certainty: vitrified clay can be recognised by its glazed, often brownish surface and short pipe lengths, concrete by its grey, grainy wall, and plastic by its smooth, even surface.

Before the camera goes in, the pipe is cleaned at high pressure – at Karo without chemicals and at up to 200 bar. With brittle or previously damaged pipes, such as vitrified clay with fragmentation or washed-out asbestos cement, the pressure and nozzle are adjusted so that the cleaning does not make the damage worse. The survey report records the material, nominal diameter, length and every finding, and is the basis for every further decision.

Practical example

A typical case in the Zurich Oberland: in a single-family home from the 1960s, water backs up in the basement drain, and a large birch tree has been standing in the garden for years. High-pressure cleaning clears the plug, and the subsequent camera inspection shows the full picture: in the basement there is a newer PE pipe, and from the house wall onwards there follows an old vitrified clay underground drain in DN 150. Three joints are leaking, roots have grown in through two of them, and a longitudinal crack can be seen at one point. Because the pipe still holds its shape, the roots are cut out and the vitrified clay pipe is rehabilitated trenchlessly with a CIPP liner. The garden and birch remain untouched, and the leaking joints are a thing of the past.

Matching services from Karo Kanaltechnik

Sewer pipe: frequently asked questions

Which material is best for a wastewater pipe?+

There is no single best material for every case. For new pipes, plastic pipes made of PE, PP or PVC are almost always used today, because they are light, tight and corrosion-free. Vitrified clay is highly resistant to acids and is still used for sewers. What matters is the location, the load, the type of wastewater and professional laying.

How long does a sewer pipe last?+

That depends less on the material than on the laying, bedding, load and roots nearby. Many old vitrified clay and concrete pipes are still in service after decades, but have leaking joints. Only a camera inspection shows whether a pipe is still in order – age alone says little about the condition.

How do I find out what material my pipe is made of?+

The year of construction, building plans, the drainage plan and visible pipes in the basement or in the inspection chamber provide the first clues. The material is determined reliably during a camera inspection: the surface, pipe length and joints differ markedly depending on the material. The survey report records the material and nominal diameter for each section.

Is an old Eternit pipe dangerous?+

An intact asbestos cement pipe that is not worked on releases hardly any fibres. It becomes dangerous when drilled, milled, cut or broken. Such pipes are therefore preferably rehabilitated trenchlessly with a CIPP liner, so that the pipe stays in the ground. If it has to be removed, Suva requirements apply.

Can a sewer pipe be renewed without digging?+

In many cases, yes. With a CIPP liner, patch liner or coating, the pipe is rehabilitated from the inside without opening up the garden, driveway or basement floor. The prerequisite is that the pipe still essentially holds its shape and has enough cross-section. Collapsed sections or a severe reverse gradient require open-cut construction.

What diameter does a wastewater pipe in a house have?+

Connecting pipes from washbasins, showers and sinks are usually in the range of around 40 to 56 mm, WC connections and soil stacks usually around 90 to 110 mm (plastic pipes each given as the external diameter). Underground drains and house connections are larger. The standard SN 592 000 and the municipality's drainage regulations govern the design.

Can different pipe materials be connected to each other?+

Yes, there are adaptors and transition couplings for this, for example from vitrified clay to plastic. Such transitions are, however, a common weak point: if they do not sit properly, displacements and leaks develop. In rehabilitation, a continuous CIPP liner often bridges the transitions at the same time.

What does it cost to have the condition of my sewer pipes checked?+

Karo charges by time: CHF 160 per hour plus CHF 60 call-out fee, excl. VAT. For the CCTV drain survey there is a surcharge from CHF 50. How long the check takes depends on the length of the pipe and the cleaning needed. A typical cleaning job at a single-family home costs around CHF 150–400, with the camera inspection added via the surcharge. All figures are guide values.

Sewer pipe in your region?

We are there for you across German-speaking Switzerland – fast, clean, with a 24/7 emergency service.